Q & A

1.
  Why do I not install the LAN under WinNT4.0?
2.
  After flashing the BIOS I got the error message: "the program file’s part number doesn’t match with your system" What should I do?
3.
  Why is the memory address D000000H ~ DFFFFFFFH occupied when I plug an add-on card in PIA-662 ?
4.
  How can I test if the WDT (watch dog timer) is working?
5.
  If PIA-662pro was previously installed on my Windows OS, can I run PIA-662?
6.
  In the power management mode, why is the LCD backlight off?
7.
  Is a printer port transfer rate of over 4 MB/x supported ?
8.
  Can I install WinCE by myself ?
9.
  Why does the HiCore-i6318 not detect PCI add-on cards on the PBP-S serial's back plane?
10.
  Why dose the IEC620 fan control board not function?
11.
  Why does the RS485 of HiCORE-i6313 not work with 2-pin RS485 device ?
12.
  Can I use the I/O address D000h~DFFFh when my system is DOC?
13.
  What is LAN boot?
14.
  What is the null modem?
15.
  What is Normal Mode, Large Mode, and LBA Mode?
16.
  what should I do when I forgot the password ?
17.
  Can I use PC133 DRAM on the PIA-662 serials?
18.
  Why can my system not shut down automatically?
19.
  Why dose my E-Server emit a long beep?
20.
  Why do I get the message, “Floppy disk(s) fail(40)" and why does the FDD status LED light stay on during boot?
21.
  Why do I get the message “Unknown PCI Universal Serial Bus” in the system manager of Win95?
22.
  How can I use the DOC in the MS-DOS environment?
23.
  Why is the HDD's size limited to 2GB in DOS?
24.
  What is the pin assignment of the PC-104 form factor ?
25.
  What is the pin assignment of the ISA slot ?
26.
  What is the pin assignment of the PCI ?
27.
  What is the difference between DOC and DOM ?
28.
  How can I use the Ultra DMA 100 mode in the HiCore-i6311, i6312 ,
i6313, i6318 ?
29.
  How can I tell the slot type of the back plane from the module name ?
30.
  Can I take out the 12V of the power connector in PIA-380 ?
31.
  What is the GPIO address for PIA-675 ,EmCore-6315 and EmCore-6352?
32.
  Why can the IDE raid of eBase not detect my HDD and emits a beep ?